Silvercrest SGS 100 A1 - Face Mask; Nose Mask

9
GB
7.3 Face mask
1. Prepare the face mask as described
(see “Assembly” on page 7).
2. Switch the on/off switch/steam flow
rate controller|7 to 1 or 2. The LED|8
lights up.
3. Figure C: after approx. 2-3 minutes,
steam is generated. Hold your face into
the face mask. Close your eyes and en-
joy the beneficial effect of the steam.
4. Figure E: the steam quantity can also
be set by means of the manual steam
flow rate controller|
11 . For more steam,
you push the controller into the direction
MAX, for less steam you push the con-
troller into the direction
MIN.
NOTE: the deeper you hold your face into
the face mask, the more intensive the effect
of the steam will be. If this becomes too
much for you, take your head a little out of
the face mask.
5. Switch the on/off switch/steam flow
rate controller|7 to 0. The LED|8 extin-
guishes and the device is switched off.
6. Wait for the device to completely cool
down.
7. Pull out the mains plug|10.
8. By a slight turn to the right you release
the face mask|1 and take it off.
9. If necessary, you take off the lid of the
aroma reservoir|3 and dispose of the
content of the aroma reservoir.
7.4 Nose mask
DANGER! Hazard caused by
hot steam!
~ Figure B: the distance to the water
container is significantly less during use
of the nose mask|2 and the steam effect
is significantly higher. Therefore, the
nose mask|2 may only be used with
stage 1.
1. Prepare the nose mask as described
(see “Assembly” on page 7).
2. Switch the on/off switch/steam flow
rate controller|7 to 1. The LED|8 lights
up.
3. Figure D: after approx. 2-3 minutes,
steam is generated. Hold your nose
into the nose mask|2. Close your eyes
and enjoy the beneficial effect of the
steam.
NOTE: the closer you place your nose to the
nose mask|2, the more intensive the effect of
the steam on the nasal mucosa will be. If this
becomes too much for you, take your nose a
little out of the nose mask|2.
4. Switch the on/off switch/steam flow
rate controller|7 to 0. The LED|8 extin-
guishes and the device is switched off.
5. Wait for the device to completely cool
down.
6. Pull out the mains plug|10.
7. Pull off the nose mask|2 from the aro-
ma reservoir|4.
8. By a slight anticlockwise turn you re-
lease the aroma reservoir|4 and take it
off.
9. If necessary, you take off the lid|3 of
the aroma reservoir|4 and dispose of
the content of the aroma reservoir.
BB*HVLFKWVVDXQDB%ERRN6HLWH0RQWDJ0DL