Silvercrest SGS 100 A1 - 4 Items Supplied; 5 Before Using for the First Time

6
GB
~ Lay the power cable such that no one
can step on it, get caught on it, or trip
over it.
~ Only connect the mains plug to a prop-
erly installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
~ Ensure that the power cable cannot be
damaged by sharp edges or hot points.
Do not wrap the power cable around the
device (Danger! Risk of cable damage!).
~ Ensure that the power cable cannot be
trapped or crushed.
~ To pull the mains plug out of the wall
socket, always pull on the mains plug,
and never on the power cable.
~ Disconnect the mains plug from the wall
socket,…
… after every use,
… if there is a fault,
… when you are not using the device,
… before you clean the device and
… during thunderstorms.
DANGER! Fire hazard!
~ Never leave the device unattended
while it is plugged in.
~ Never heat the device if it doesn't con-
tain any water.
DANGER! Risk of injury
through burning/scalding
~ The water is boiling in the water con-
tainer during operation. Any contact
with boiling water or hot steam may
cause serious injury.
~ Do not touch the hot inner parts of the
device.
~ Allow the device to cool down com-
pletely before you transport or clean it.
~ Allow all parts to cool down before re-
moving them from the device.
WARNING! Risk of material damage
~ Use the original accessories only.
~ Never place the device on hot surfaces
(e.g. hob plates) or near heat sources or
open fire.
~ Do not use any astringent or abrasive
cleaning agents.
~ Do not expose the device to tempera-
tures below -10 °C or above +40 °C.
4. Items supplied
1 base unit|6
1 face mask with aroma reservoir|1
1 nose mask|2
1 aroma reservoir for the nose mask|4
1 lid for the aroma reservoirs|3
1 measuring beaker|9
1 operating instructions
5. Before using for the
first time
• Remove all packing material.
• Check that the device is undamaged.
• Clean the device prior to its first
use ! (see “Cleaning” on page 10)
• Place the device on level, water insensi-
tive and (to the maximum extent possi-
ble) non-slip ground.
• Select the location such that you can
comfortably sit in front of the device.
BB*HVLFKWVVDXQDB%ERRN6HLWH0RQWDJ0DL