EasyManua.ls Logo

Silvercrest SGS 100 A1 - 6 Assembly; Fill in Water; Herbs and Oil; Set-Up with Face Mask

Silvercrest SGS 100 A1
79 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
GB
6. Assembly
You can use the facial sauna either with the
face mask|1 or the nose mask|2.
6.1 Fill in water
WARNING! Risk of material damage!
~
Please do not add any additives to the
water in the water container|
5
such as
e.g. oils. After the water has evaporated
these additives may burn in and cause
damage to the water container|
5
.
The measuring beaker|9 is labelled
with a scale (5 min, 10 min, 15 min)
on both sides:
- With switch setting 1 of the steam
flow rate control|7 (lower steam
quantity) use scale 1.
- With switch setting 2 of the steam
flow rate control|7 (higher steam
quantity, only for use with the face
mask|1) use scale 2.
1. Fill tap water into the measuring beaker|
9
:
at least up to the minimum marking
5min,
but no more than to the max. marking
15 min
of the used scale
1
or
2
.
2. Pour the water into the water container
|
5.
6.2 Herbs and oil
You can place herbs, tea leafs or oils (on a
cotton ball) into the aroma reservoirs|1
and|4. These will then pass their beneficial
effect on to you together with the steam.
Tips
If you are not sure with regard to the ef-
fect of herbs or oils, ask your pharma-
cist or read the package leaflet.
Always add only just a few drops of oil
to a cotton wool pad.
If you wish to use very fine herbs or
even powders, ensure that these do not
ingress into the water container|5. It is
best if you first place such herbs/pow-
ders into a small filter bag or place the
same on a cotton wool pad.
6.3 Set-up with face mask
1. Place the face mask|
1
on the basic unit|
6
.
- The opening of the face mask|1 is lo-
cated above the on/off switch|7.
- The lateral lugs must fit into the re-
cesses on the basic unit|6.
2.
If required:
If necessary, take the lid|
3
off the aroma reservoir|
1
. For this, grab
both lugs and pull off the lid|
3
upwards.
Fill some tea leafs or herbs into the inner
ring of the aroma reservoir|
1
and put
the lid|
3
of the aroma reservoir on.
NOTES:
Please add oils one drop at a time to a
cotton wool pad and place the same
into the aroma reservoir|1.
If you are not sure about the effect of the
herbs or oils (stinging eyes etc.), ask a
pharmacist before first use.
3. Turn the face mask|1 a bit clockwise un-
til it is connected firmly with the base
unit|6.
4. Connect the mains plug|10 with a wall
socket. The on/off switch|7 is set to 0.
BB*HVLFKWVVDXQDB%ERRN6HLWH0RQWDJ0DL

Table of Contents

Related product manuals