54 - English
Ask your water utility about the water hardness.
Water hardness
Regeneration
at every X
programme
sequence*
Salt con-
sumption
P must be
pressed
Display
LED ON/LED OFF
dH
(degree
of German
hardness)
mmol/l
(milli-
mole per
litre)
ECO
0–5 0–0.94 H1 – Press 1 x OFF OFF ON
6–11 1.0–2.0 H2 10 Press 2 x OFF ON OFF
12–17 2.1–3.0 H3 5 Press 3 x
(Factory set-
tings)
OFF ON ON
18–22 3.1–4.0 H4 3 Press 4 x ON OFF OFF
23–34 4.1–6.0 H5 2 Press 5 x ON OFF ON
35–55 6.1–9.8 H6 1 Press 6 x ON ON OFF
* When regeneration is carried out during a programme, an additional 2.2 l of water is required,
the energy consumption increases by 0.01 kWh and the programme is extended by 4 minutes.
Close the appliance door.
Press the button
(18)
to switch on the appliance and make settings.
Press and hold the P button (17) for approx. 5 seconds.
Then press the P button (17) several times in accordance with the table above to set the
salt consumption.
If you do no press any button within 5 seconds, the appliance switches to standby
mode.
To Next Page
Loading...
