Silvercrest SHAZB 29.6 B2 - Base station; Fastening the base station; Storing and charging in the base station

28
GB
5. Base station
5.1 Fastening the base
station
Fasten the base station26 to the wall using
the drilling template and the fixing material
included in the delivery.
NOTE: before fastening, check that the fix-
ing material included in the delivery meets
your requirements (e.g. wall structure). If not,
replace it with suitable fixing material.
1. Look for a place on the wall for the base
station26. Make sure that there is a
wall socket nearby.
2. Using the drilling template, draw the
marking for the drill holes on the wall.
3. Drill holes with a diameter of 6 mm us-
ing a drill.
4. Insert the rawlplugs into the drill holes.
5. Tighten the screws in the rawlplugs.
6. Hang the base station26 up on the
wall and check for a secure hold.
5.2 Storing and charging in
the base station
The base station26 is used as a holder and
battery charger for the suction device2 with
the suction pipe32, the brush nozzle43
and the crevice nozzle44. After every use,
hang the suction device2 up in the base sta-
tion26.
• Hang the suction de-
vice2 with the re-
cess between the
charging contacts5
on the hook23 of the
base station26.
• The battery29 will
be charged automati-
cally.
• The suction pipe32
remains attached to
the suction device2.
•
The crevice nozzle 44
and the brush noz-
zle43 can be
plugged onto the
holders27.
• The floorhead35
can stay connected to
the suction pipe32.
26
27
26
23
27
26
32
2
__338023_Handstaubsauger_B8.book Seite 28 Mittwoch, 15. Juli 2020 10:25 10