EasyManua.ls Logo

Silvercrest SHAZB 29.6 B2 - Charging the battery

Silvercrest SHAZB 29.6 B2
143 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
29
GB
6. Charging the battery
NOTES:
Fully charge the battery29 before us-
ing it for the first time.
It takes approx. 3.5 hours to fully
charge the battery.
After every use, hang the suction de-
vice2 up in the holder of the base sta-
tion26. This ensures that the suction
device will always work at full power.
The battery29 is not damaged by reg-
ular charging.
Charging the suction device via the
base station
1. Connect the power
cable of the power
adapter25 to the
socket24 on the
top right-hand side
of the base sta-
tion26.
2. Plug the plug into a
suitable wall socket.
The wall socket must still be easily accessible
after connection.
3. After every use,
hang the suction de-
vice2 up on the
hook23 of the
base station26.
The LEDs of the
charging indica-
tor21 are lit or start
flashing. When all
LEDs are lit, the bat-
tery29 is fully
charged.
A full charge is enough to use the vacuum
cleaner in ECO mode for approx.
40 minutes or in normal mode for approx
10 minutes.
Connecting the suction device
directly to the mains
You can also charge the battery29 when
the suction device is not in the battery charg-
er.
Connect the power cable of the power
adapter25 directly to the socket4 un-
der the handle3 of the suction de-
vice2.
Then plug the plug into a suitable wall
socket.
NOTE: the battery29 has another charg-
ing indicator28. This is only visible when
the suction device is not hanging in the base
station26.
LED signals during charging
- Lit LEDs show the current charging state.
- A flashing LED indicates that the battery
is charging.
- When all 4 LEDs are lit continuously, the
battery is fully charged.
LED signals during operation
- Lit LEDs show the current charging state.
- Unlit LEDs show the consumed portion.
- One LED flashes: battery29 weak, the
device will switch off soon.
NOTE: If the rotating brush37 / hard floor
roller40 is blocked, the vacuum cleaner
switches off. The LEDs21 /28 /39 flash
for approx. 7 seconds. Only then can the
vacuum cleaner be switched on again.
24
25
2 2621
GB_338023_Handstaubsauger_.fm Seite 29 Mittwoch, 16. September 2020 10:46 10

Table of Contents

Related product manuals