Silvercrest SHAZB 29.6 B2 - Installation; Engaging and disengaging connections; Adjusting the length of the brush nozzle

30
GB
7. Installation
CAUTION:
~ During all assembly steps, the vacuum
cleaner must be switched off.
7.1 Engaging and disen-
gaging connections
All nozzles can be connected either to the
suction pipe32 or directly to the suction de-
vice2.
The crevice nozzle44 and the brush noz-
zle43 have a simple locking device.
• Plug the nozzle onto the opening on the
suction pipe34 or the opening on the
suction device16 until it audibly clicks
into place.
• The small ridge41 on the nozzle fits
precisely into the groove on the sock-
et17 or33.
• To release the connection, press
the cor-
responding release button 42 .
NOTE: the release button42 has only been
numbered once, because it looks the same
and functions the same on the crevice noz-
zle44 and the brush nozzle43.
The floorhead35 and the upper end of the
suction pipe32 have two release but-
tons31 (on both sides).
• When assembling, ensure that the lock
clicks into place on both sides.
At the same time, the plug30 is con-
nected to the socket17 on the suction
device2 or the socket33 on the lower
end of the suction pipe32.
• To release the connection, press both re-
lease buttons31.
NOTE: the release buttons31 and the
plug30 are only numbered once. Those on
the floorhead35 and the upper end of the
suction pipe32 look the same and function
the same.
7.2 Adjusting the length of
the brush nozzle
• Press the button45 on top of the brush
nozzle43 and slide the brush nozzle
section to a position where it audibly
clicks into place.
32
42
33
41
2
41
17
__338023_Handstaubsauger_B8.book Seite 30 Mittwoch, 15. Juli 2020 10:25 10