32
GB
8. Vacuum cleaning
CAUTION:
~ During vacuuming, all filters and the
dust container8 must be assembled at
all times.
1. Assemble the accessories needed.
2. Insert the battery29 into the battery
compartment7.
3.
Press the on/off switch
1 to switch
the device on.
- If you want to reduce the suction pow-
er, press the ECO22 button once.
The LED under the button will be lit
green. To switch off the function, press
the button again.
4. When the dust container8 is full to the
marking MAX, stop vacuuming and
empty the dust container8.
5. To switch off the suction device2, press
the on/off switch 1 again.
6. Empty the dust container8 and hang up
the parts back in the base station26.
NOTES:
• After switching on, it takes 1 - 2 seconds
before the device can be switched off
again.
• When using the floorhead35, the LEDs
of the LED bar39 are automatically
switched on. This allows you to see the
area to be vacuumed at all times, even
in dark corners.
• After switching on, it takes 1 - 2 seconds
before the device can be switched to the
mode with reduced suction power using the
ECO
22
button
.
•
If the rotating brush
37
/ hard floor roll-
er
40
is blocked, the vacuum cleaner
switches off. The LEDs
21
/
28
/
39
flash for approx. 7 seconds. Only then
can the vacuum cleaner be switched on
again.
Using the accessories
In the following table, you will find an over-
view of the cleaning tasks for which the var-
ious accessories are particularly suitable.
No. Nozzle Use
35
+37
Floorhead
with rotating
brush
Versatile use for
cleaning floors
35
+40
Floorhead
with hard floor
roller
For cleaning hard
floors (e.g. tiles,
laminate)
43
Brush nozzle Sofas, armchairs,
mattresses, furni-
ture, textiles, book
shelves
44
Crevice noz-
zle
Cabinets, crevices,
corners, gaps
__338023_Handstaubsauger_B8.book Seite 32 Mittwoch, 15. Juli 2020 10:25 10
To Next Page
Loading...
