Silvercrest SHAZB 29.6 B2 - Dust container and filters; Assembling the dust container; Emptying the dust container

33
GB
9. Dust container and
filters
CAUTION:
~ During vacuuming, all filters and the
dust container8 must be assembled at
all times.
Every operation requires the dust contain-
er8 and all filters to be inserted:
- the metal filter10 inside the dust
container8,
- the paper filter13 inside the filter carri-
er12,
- the motor protection filter15 on the pa-
per filter13,
-the exhaust air filter18 at the top of the
suction device2.
9.1 Assembling the dust
container
• Place the dust con-
tainer8 onto the suc-
tion device2 in such
a way that the arrow
above the open pad-
lock symbol points to
the z9 marking.
• Turn the dust contain-
er8 clockwise until it
clicks into place.
Now the arrow
above the closed
padlock symbol
points to the z9
marking.
• To remove, turn the dust container8 an-
ticlockwise and then pull it off down-
wards.
9.2 Emptying the dust
container
• To empty the dust
container8, you do
not need to remove it
from the suction de-
vice2.
• Hold the suction de-
vice above a waste
container and then
press the button14
to open the flap11
at the bottom of the
dust container8.
•To lock the flap11, close it again until it
audibly clicks into place.
9.3 Paper filter (HEPA)
The paper filter13 sits inside the filter carri-
er12.
• Remove the paper filter13 by pulling it
out upwards using the small handle in
the middle.
• To insert, place the
paper filter13 into
the filter carrier12
from above.
8
9
14
11
13
12
__338023_Handstaubsauger_B8.book Seite 33 Mittwoch, 15. Juli 2020 10:25 10