Silvercrest SHAZB 29.6 B2 - Paper filter (HEPA); Metal filter; Motor protection filter; Exhaust air filter

34
GB
9.4 Metal filter
The metal filter10 is
firmly attached to the fil-
ter carrier12. The filter
carrier can easily be
pulled out using the met-
al bracket.
• When assembling, place the filter carri-
er12 into the dust container8 straight
on. Ensure that it sits completely straight
in the dust container.
9.5 Motor protection filter
On top of the paper fil-
ter13 sits the motor
protection filter15.
• Remove the dust con-
tainer8 from the suc-
tion device2.
You can then remove
the motor protection
filter15 from on top
of the paper filter13.
9.6 Exhaust air filter
There are two small exhaust air filters18 at
the top of the suction device2.
1. To remove, pull on the unlocking mecha-
nism20 on the filter cover19 and lift it
off.
2. On the underside of the filter cover19,
you will find the two exhaust air fil-
ters18. Remove them.
3. Insert the new exhaust air filters18.
4. Reinsert the filter cover19, pull on the
unlocking mechanism20 and close the
filter cover19 completely. Then release
the unlocking mechanism20.
10
12
13
15
18
20
19
__338023_Handstaubsauger_B8.book Seite 34 Mittwoch, 15. Juli 2020 10:25 10