Silvercrest SHBR 560 B1 - Cleaning the Waste Water Tank; Waste Water Tank Maintenance Notes; Waste Water Tank Emptying Procedure

GB
│
IE
│
15 ■
SHBR 560 B1
NOTE
► After every use, carry out a self-cleaning of the appliance (see section
Self-cleaning function).
Ƈ Clean the appliance with a moist cloth or rag. For stubborn soiling use a mild
detergent on the cloth.
Cleaning the waste water tank
NOTE
► Empty the waste water tank
2 after every use and as soon as the dirty
water has reached the MAX marking.
► When emptying the waste water tank 2 make sure that the drain (e.g. the
wash basin) is not blocked by hair or coarse dirt.
► Once the waste water tank
2 is full, the float 8 causes the suction motor
to switch off automatically.
Ƈ Proceed as follows to empty the waste water tank 2:
1. Press the knob at the top of the waste water tank
2 downwards (see fig. 20).
Hold the handle of the waste water tank 2 while pressing the knob down-
wards.
2. Pull the waste water tank
2 forwards out of the appliance (see fig. 20).
Ƈ Pull the lid of the waste water tank
9 upwards out of the waste water tank 2
(see fig. 21).
Fig. 20 Fig. 21
Ƈ Tip out the dirty water and dirt (see fig. 22).
Ƈ Rinse the waste water tank
2 in hot running water (see fig. 23).