Silvercrest SHBR 560 B1 - Manual Cleaning of Brush System; Detaching Rotary Brush; Washing Brush Components

GB
│
IE
│
19 ■
SHBR 560 B1
Ƈ Take hold of the bracket on the left side of the rotary brush 6 and pull it
upwards to remove the rotary brush from the foot section 3 (see fig. 34).
Fig. 33 Fig. 34
Ƈ Clean the splash guard
7 and the rotary brush 6 in hot running water (see
fig. 35).
Ƈ If the brush chamber is dirty, wipe it out with a damp cloth or rag (see fig. 36).
Fig. 35 Fig. 36
Ƈ Allow the rotary brush
6 and the splash guard 7 to dry completely before
fitting them back onto the appliance (see fig. 37).
Ƈ You can also place the rotary brush
6 upright in the rotary brush holder 5 on
the parking and cleaning station for drying (see Figure 38).