Silvercrest SHBR 560 B1 - Refitting Brush System Components; Drying Brush Components; Reattaching Brush Components

■ 20
│
GB
│
IE
SHBR 560 B1
Fig. 37 Fig. 38
Ƈ Fit the rotary brush
6 and the splash guard 7 back onto the appliance by
first pushing the rotary brush 6 onto the fitting on the right side of the foot
section 3 (see fig. 39).
Ƈ Then push the bracket on the left end of the rotary brush
6 into the opening on
the left side of the foot section 3 until the rotary brush 6 audibly clicks into
place (see fig. 40).
Fig. 39 Fig. 40
Ƈ Replace the splash guard
7 by first aligning it with the bracket on the foot
section 3 (see fig. 41).
Ƈ Then push the splash guard
7 into position until it audibly clicks into place on
the foot section 3 (see fig. 42).
Fig. 41 Fig. 42