Silvercrest SHBS 1000 B1 - Disposal; Appliance and Battery Disposal

9
SHBS 1000 B1
GB
Cut length add-ons
7
:
♦ Select a suitable cut length add-on
7
to match your required hair length (4 - 6
mm / 7 - 9 mm / 10 - 12 mm / 16 - 18 mm / 22 - 24 mm / 28 - 30 mm).
♦ Click the selected cut length add-on
7
onto the trimmer block
from behind.
Ensure that both pins in the cut length add-on
7
correctly locate into the side
cutouts in the trimmer head holder.
♦ You can use the slide switch
2
to make fi ne adjustments to the required cut
length
7
. For example, if you want to cut your hair to 22 mm length, take a cut
length add-on
7
for hair lengths of 22-24 mm and push the slide switch
2
for
fi ne length adjustment upwards as far as possible (0.5 mm).
NOTE
►
Variable adjustment of the fi ne adjustment downwards increases the cut
length to 22.5 mm (with fi ne adjustment 1.0 mm); to 23 mm (with fi ne
adjustment 1.5 mm) or to 24 mm (with fi ne adjustment 2.5 mm).
Cut length
add-on
7
(mm)
Cut length* with fi ne length adjustment (mm)
0.5 1.0 1.5 2.0 2.5
4 - 6 4 4.5 5 5.5 6
7 - 9 7 7.5 8 8.5 9
10 - 12 10 10.5 11 11.5 12
16 - 18 16 16.5 17 17.5 18
22 - 24 22 22.5 23 23.5 24
28 - 30 28 28.5 29 29.5 30
* Please note that the cut length can deviate from the stated length depending
on the angle of cut.
♦ Switch the hair and beard trimmer on by pressing the ON - OFF switch
3
.
♦ Run the hair and beard trimmer slowly through your hair.
♦ When doing so, hold the appliance so that the selected cut length add-on
7
is
as fl at as possible against your scalp.
♦ Always cut from your neck towards the top of your head, or from your forehead
and temples upwards towards the middle of the head.
IB_31711_SHBS1000B1_HR_RO_BG_GR.indb 9IB_31711_SHBS1000B1_HR_RO_BG_GR.indb 9 03.02.14 08:1903.02.14 08:19