To Next Page

To Previous Page

~ If the device is used in a bathroom, the power unit must be

pulled out after use, as the proximity of water represents a

hazard, even when the device is switched off.

~ Installation of a residual current device (FI/RCD) with a rat-

ed residual operating current of no more than 30 mA is

recommended to provide additional protection. Ask your

electrician for advice. The installation should only be car-

ried out by a qualified electrician.

DANGER! Risk of electric shock

~ Never put the device into operation if there are visible

damages to the device, the battery charger or the cable or

if the device has been dropped before.

~ Connect the cable to the device/battery charger before

plugging the power unit into a wall socket.

~ Only connect the power unit to a properly installed, easily

accessible wall socket, the voltage of which corresponds

to the specifications on the rating plate. The wall socket

must continue to be easily accessible after the device is

plugged in.

~ Ensure that the cable cannot be damaged by sharp edges

or hot surfaces.

~ Ensure that the cable is not trapped or crushed.

~ When removing the power unit from the wall socket, al-

ways pull the power unit and never the cable.

~ Pull the power unit out of the wall socket, …

… after every use,

… after each charging process,

… if there is a fault,

… before connecting the device to the cable,

… before you clean the device and

… during thunderstorms.

~ To avoid any risk, do not make modifications to the de-

vice. Repairs must be carried out by a specialist workshop

or the Service Centre.

BB.5$B%ERRN6HLWH'LHQVWDJ'H]HPEHU

Silvercrest SHBS 3.7 A1 User Manual

Questions and Answers: