Silvercrest SHFD 1400 C1 - 5. Getting Started; Initial Setup and Operation

76
GB
5. How to use
• Remove all packing material. The inte-
rior in particular must be com-
pletely free of packaging
remains such as polystyrene
particles.
DANGER - fire hazard!
On the back of the device you will find the air
outlet 13 . Hot air escapes from the air out-
let13 during operation .
~ Never cover the air outlet13.
~ Do not use the hot air fryer directly un-
der wall units or wall sockets and not
near to any curtains, paper or any simi-
lar flammable objects.
~ Make sure that there is free space on all
sides and above the device.
~ Remove the cardboard between frying
basket5 and pan10.
Figure A:
1. Use the handle9 to pull the pan10 out
of the housing1.
2. Slide the safety catch7 in the direction
of the arrow.
3. Press the button for unlocking the frying
basket8 and lift the frying basket5 up-
wards out of the pan10.
NOTE: when in operation for the first time,
some smoke and odour may be generated
by the device. This is due to the assembly
materials used for the heating element2
and is not a fault in the product. Ensure ad-
equate ventilation.
• Remove protective films and adhesive
strips from the device, but do not re-
move the rating plate on the underside
of the device.
• Check that all accessories are present
and undamaged.
•
Clean the device and all accessories be-
fore using for the first time (see “Clean-
ing” on page 87).
• Place the device on a dry, level, non-
slip, heat-resistant surface.
• Insert the mains plug11 into a wall
socket corresponding to the specifica-
tions of the rating plate. The wall socket
must also be easy to reach after switch-
ing on the device.
12
13
__438124_2304_B5.book Seite 76 Mittwoch, 21. Juni 2023 9:00 09