■ 8
│
GB
│
IE
│
NI
│
CY
SHFR 1450 A1
Before first use
Before you use the hot air fryer for the first time, please proceed as follows to
remove any remaining production residue:
RISK OF ELECTRIC SHOCK
► Do not allow the mains cable to come into contact with the hot parts of the
hot air fryer. Risk of electric shock!
WARNING – RISK OF INJURY!
► Parts of the appliance, especially the hotplate , accessories and lid
get very hot during use. Do not touch these parts. Only touch the operating
elements and the handle of the cooking container . When removing the
food, use oven gloves to prevent burns.
1) Place the appliance on a horizontal, level, stable and heat resistant surface.
NOTE
► If you wish to place the hot air fryer below the cooker extraction hood,
ensure that the cooker is switched off.
2) Insert the plug into a mains power socket. The time display flashes, there
will be a beep and the display lights up blue. The appliance is now in
standby mode.
3) Press the lid release button . The appliance lid flips open.
4) Remove the cooking grill , the measuring cup 3and the stand -.
5) Add about 300–500 ml of water to the cooking container and close the
lid by pushing it down until it clicks into place.
6) Press the SET button and select the
programme using the arrow but-
tons ▲ ▼ . Use the ▲ arrow button to navigate clockwise and the ▼ arrow
button to navigate anticlockwise through the menu.
Keep the button pressed down to move quickly through the menu.
7) Press the SET button again and the time display flashes. Use the arrow
buttons ▲ ▼ to set a time of 20 minutes. Keep the button pressed down to
run through the digits quickly.
8) Press the ON/OFF button to start the programme. The display lights
up orange during operation.
When the programme is completed, you will hear ten beeps and the display
lights up blue. The appliance is back in standby mode. The ventilation in the
lid runs on for a while to cool down the appliance.
To Next Page
Loading...
