16
GB
5. Operation
DANGER! - Fire hazard!
~ Never cover the device or place it on
soft objects (e.g. towels). As long as the
device is switched on and/or hot, al-
ways place it on a stable, flat, heat-re-
sistant surface.
DANGER! Risk of injury
through burning!
~ Never touch the hot brush insert with
ceramic coating|1.
NOTE: Before using it for the first time,
switch the device on for a few minutes and
set it to the highest temperature (200 °C). As
a result of the manufacturing process, you
may notice a slight odour. This is normal and
only occurs during first use. Ensure that the
room is well ventilated.
5.1 Switching on/off and
adjusting temperature
1. Place the device on a heat-resistant sur-
face.
2. Connect the mains plug|6 to a properly
installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
3. Press the on/off button |4 for ap-
prox. 2 seconds to switch the device
on. The display|2 shows:
- 160: if prior to switching the device
on, the mains plug was disconnect-
ed.
- The value set last if the mains plug
had not been disconnected after the
device was switched off last.
4. Pressing the +/–|3 buttons, set the de-
sired temperature between 100 °C and
200 °C using 20 °C increments. Short-
ly after, increasing bar segments on the
display|2 indicate that the device is
heating up.
NOTE: decreasing bar segments indicate
that the device is cooling down. Wait un-
til the desired temperature appears on the
display before straightening your hair.
5. In order to avoid changing the tempera-
ture by accidentally pressing the +/-
buttons |3, these buttons are locked au-
tomatically a few seconds after being
pressed last.
-The display|2 shows if the buttons
are locked
- To unlock: press one of the +/-|3
buttons for approx. 2 seconds. The
buttons are now unlocked. The dis-
play|2 stops showing .
6. Press the on/off button |4 for ap-
prox. 2 seconds to switch the device
off.
7. Allow the device to cool down on the
heat-resistant surface.
Switching off automatically
If you do not press a button on the switched-
on device for 30 minutes, it will switch off
automatically. Before this happens, the tem-
perature display will flash in the display|2.
Press the on/off button |4 for approx.
2|seconds to switch the device back on.
__291954_Haar-Glaettungsbuerste_B8.book Seite 16 Freitag, 12. Januar 2018 12:01 12
To Next Page
Loading...
