Silvercrest SHSD 2600 A1 - Page 39

SilverCrest SHSD 2600 A1
English - 37
Position Symbol Description
1 – Temperature display
2 –
V
olume displa
y
3 Start button: Press the start button (3) to produce the set volume of hot
water. Press the start button (3) while water is being dispensed to cancel
the process.
4
W
ater volume button: If necessary, press the water volume button
(4) repeatedly to select the water volume you want. You can switch
cyclically between l l l, 100, 200 and 300 ml.
WARNING! Selecting “l l l” drains the whole content of the water
reservoir (9). Only select this option if you want to clean the device and
have placed a suitable size bowl under the water outlet instead of the
catcher plate (12).
5
W
ater temperature button: Press the water temperature button (5)
repeatedly to select the water temperature you want. You can switch
cyclically between rt, 55, 65, 75, 85 and 100 °C.
If you select “rt”, the water in the water reservoir (9) is not heated. This is
used, for example, for rinsing through after cleaning and descaling the
device.
6 Unlock button: Press the unlock button (6) for at least 3 seconds to
unlock the device. You can then select the water temperature and volume
and start the dispensing process.