Silvercrest SKMC 1200 B2 - Using the Spatula; Removing the Blender Jug; 10 Operating the Device; Power Supply

14
GB
9.8 Using the spatula
The spatula21 is used to stir the ingredients and to remove
the cooking pot19.
CAUTION:
~ The spatula21 must not be used with the mixer attach-
ment20 in place. Otherwise, the spatula21 might be
caught in the mixer attachment20.
~ Do not use any other kitchen utensil to stir the ingredi-
ents. The utensil might get into the blades and cause
damage.
•Always stir clockwise. The spatula21 is designed
such that when stirring clockwise it cannot come into
contact with the blade assembly18 even if that is run-
ning.
• The hook on the rear of the spatula21 can be used to
remove the hot cooking pot19 without having to
touch it directly. Simply hook on the metal bracket of
the cooking pot19 and pull it out upwards.
Tips for changing the tip and for cleaning: (see “Cleaning,
checking and replacing the spatula” on page 32).
9.9 Removing the blender jug
DANGER! Risk of injury through burning!
~ If the contents of the blender jug5 are hot, the lid23
must be opened slowly and carefully.
~ The mass in the blender jug is still in motion immediate-
ly after puréeing and could spill out if the lid is opened
too quickly. Therefore, wait approx. 10 seconds after
puréeing before opening the lid.
1. Press and turn the lid23 with both hands anticlock-
wise and then remove it.
2. Remove the blender jug5 upwards.
10. Operating the device
For safety reasons, the settings described in this chapter,
can only be selected when the device has been assembled
completely.
10.1 Power supply
• Connect the mains plug15 to a suitable wall socket.
The wall socket must still be easily accessible after con-
nection.
• Pull only as much cable as necessary out of the cable
compartment16.
10.2 Switching the device on and off
NOTE: switching on for the first time is described in chap-
ter “Switching on for the first time and connecting to the In-
ternet” on page 7.
• Set the on/off switch7 at the rear on the right to I:
- The touchscreen8 lights up.
- After some time a signal sounds and the start menu
appears on the screen.
.
• Set the on/off switch7 on the back to 0 to switch the
device off.
Auto Recipes Settings
00:00 0
°C
Turbo Anti-clockwise Weighing
0
0
__317552_MC-Connect_GB.book Seite 14 Donnerstag, 21. März 2019 10:53 10