Silvercrest SKMC 1200 C3 - Replacing the Blade Socket

36
GB
18.7 Replacing the blade socket
If you process larger quantities than those specified in
these instructions (e.g. dough with more than 600 g of
flour), the blade socket12 can become so worn out that
the blade assembly19 no longer turns correctly.
If this happens, replace the blade socket12 with a new
one. Comply the specified maximum quantities in future.
Figure A: a spare blade socket12 including a silicone
cover26 is included with the device as delivered.
You can also reorder this spare part (see “How to order ac-
cessories” on page 38).
Removing the old blade socket
1. Press your thumb down on the silicone cover26 and
simultaneously reach under the rim of the old blade
socket12. Pull the old blade socket12 out upwards.
You may need to “wobble” it a bit before the blade
socket12 becomes loose enough to be removed.
Inserting the new blade socket
2. Place the blade socket12 onto the drive axle. The re-
cess in the blade socket12 needs to be inserted to
match the flattened sides of the drive axle. The blade
socket12 clicks into place on the drive axle.
3. Insert the silicone cover26 into the blade socket12.
18.8 Storage
Store the device so that it is protected against dust and dirt
and out of the reach of children.
__338924_1907_MC-Connect_GB_online.book Seite 36 Donnerstag, 12. Dezember 2019 10:09 10