SKMH 1100 A1 23
11. Malfunctions, causes and solutions
11.1 Malfunctions during operation
Malfunction Cause Solution
Appliance fails to start Blender jug 6 is not correctly
positioned
Position the blender jug 6 correctly
(see “7.3 Positioning the blender
jug” on page 12)
Lid 25 of the blender jug 6
is not correctly positioned
Position the lid 25 correctly (see
“7.5 Positioning the lid of the
blender jug” on page 13)
No power supply Check the plug and if necessary
also the fuse
Incorrect power supply Make sure to use the correct power
supply (see “6.1 Connecting the
power supply” on page 9)
There is liquid
underneath the
appliance
Blade assembly 20 is not
correctly seated and is
leaking
Position the blade assembly 20
correctly (see “7.2 Inserting and
removing the blade assembly” on
page 12)
The seal of the blade
assembly 19 is defective
Install a new seal 19 (see
“10.6 Ordering seals” on page 22)
Liquid has escaped from the
blender jug 6 and has
drained through the base
unit’s overflow hole 17 onto
the underlay (see
“6.9 Overflow” on
page 11)
When blending liquids on level 10
or using the pulse button 9, do not
exceed a quantity of 1 litre in the
blender jug 6, otherwise liquid may
spray out. At speeds lower than 10,
the blender jug may contain up to
2l.
Liquid is leaking from the
lid 25 of the blender
jug 6
Seal 24 is not correctly
positioned
Position the seal 24 correctly (see
“10.3 Cleaning the accessories” on
page 21)
Seal 24 is defective Install a new seal 24 (see
“10.6 Ordering seals” on page 22)
Unable to select a
temperature
You have selected a speed
in the range 4 – 10
Select a speed in the range 0 – 3
(see “6.6 Setting the speed” on
page 10)
RP93471 Küchenmaschine mit Heizung LB6 Seite 23 Donnerstag, 14. August 2014 3:38 15
To Next Page
Loading...
