Working with the blender
1) If necessary, press down the release lever and press the swivel arm downwards into the working
position.
2) Remove the drive protection lid 1.
3) Place the blender 0 on the blender drive unit % in such a way that the protrusions on the underside of
the blender 0 engage with the recesses of the blender drive unit %. The
symbol on the blender 0
must be pointing to the
symbol on the appliance. Turn the blender 0 anticlockwise as far as it will go.
The
symbol on the blender 0 must then be pointing to the symbol on the appliance.
4) Add the ingredients.
5) Place the blender lid . with measuring cup ! in position in such a way that the lips of the blender
lid . also seal the spout.
6) Turn the rotary switch to the desired level.
Ident. no.: SKV1200A1-072016-3
short_IB_281064_GB.indd 2 20.10.16 14:28
DIN A5 148 mm x 210 mm
To Previous Page
Loading...
