SilverCrest SLS 2200 A1
English- 11
Before you start
Remove the solar battery charger and the accessories from the packaging.
Fitting the suction pads
Fix the four suctions pads (O) to the bottom of the solar battery charger as
shown in the diagram below. Insert the suction pads (O) into the hole. Next, fix
the suction pads (O) by sliding them into the smaller hole.
You can now mount the solar battery charger to a flat, even surface using the
suction pads.
The surface should be free of dust, oil and grease for the
suction pads to stick well.
To Next Page
Loading...
