Silvercrest SLS 35 A1 - Operation after Initial Use Curl Styles; Classic Curls; Soft Curls

11 GB
Operation / After initial use / Curl StylesBefore first use / Operation
Slide the curling iron
along the section of
hair almost to the
root. Be careful not
to touch the scalp or
the hands with the
heating rods
2
.
Rotate the curling iron
360 ° and slowly
move it down again,
along the entire sec-
tion of hair. Be sure to
keep the curling iron
at the same angle so
the section of hair
does not tangle whilst
styling.
Note: After 30 minutes appliance will automati-
cally enter standby mode (120°C). The appliance
will automatically shut off after 45 minutes, indi-
cated by the LCD temperature display
3
2 min-
utes prior.
After initial use
To switch the curling iron off after use, hold the
ON / OFF button
6
for three seconds. Be sure
to first deactivate the keylock. The LCD temper-
ature display
3
will read „OFF“.
Unplug the product from the mains socket after
use. Do not wrap the power cord
7
around
the product!
Set the curling iron on a sturdy, level, non-flam-
mable surface to cool down. Be sure the barrels
2
does not touch the surface! Fire hazard!
Allow the barrels
2
of the curling iron to cool
down completely. Then store the curling iron in a
dry location out of the reach of children. Or ha ng
the curling iron from a hook by the hanger
loop
8
.
Curl Styles
The curling iron can be used to try out different
style curls.
Classic curls
Place a section
of hair between the
barrels
2
and
move it almost all
the way to the root
of the hair.
Rotate the curling
iron 360 ° and
slowly move it down.
This will make
classic curls.
Note: For tighter
curls, move the curl-
ing iron through the
hair slower.
Soft curls
Place a section of
hair between the
barrels
2
and
move it almost all
the way to the root
of the hair.