EasyManua.ls Logo

Silvercrest SMWC 700 C1 - Using Multiple Programmes

Silvercrest SMWC 700 C1
386 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English - 27
Press the start button (13) to start the programme.
Two short beeps will sound after half the cooking time has elapsed.
Open the microwave door (11). Turn over the food or stir it to guarantee even
defrosting.
Then close the microwave door (11) again and press the
start button (13) again to
continue the programme.
If the food is not fully defrosted after the time has elapsed, start the process again. To
do so, use the power level P30 for several minutes to fully defrost the food.
11.4.2. Time defrost
You can set the desired duration of the defrosting programme.
Then press the defrost button (17) twice to select the desired defrosting mode by
time.
dEF2 will appear on the display (3).
Turn the control knob (14) to set the desired defrost time in minutes and seconds
(0:00).
The longest defrosting time is 95minutes.
The following list details the approximate defrost times required for various weights:
Food weight Time
100 g 04:44 minutes
600 g 30:04 minutes
1000 g 50:20 minutes
1500 g 75:40 minutes
2000 g 95:00 minutes
Press the start button (13) to start the programme.
If necessary, open the microwave door (11) approximately halfway through the
cooking time. Turn over the food or stir it to guarantee even defrosting.
Then close the microwave door (11) again and press the start button (13) again to
continue the programme.
If the food is not fully defrosted after the time has elapsed, start the process again. To
do so, use the power level P30 for several minutes to fully defrost the food.
11.5. Using multiple programmes
The product can carry out multiple programmes consecutively. Any two sequences can be
programmed to run automatically.
Set the programme but only press the start button (13) when the last programme

Table of Contents

Related product manuals