■ 8
│
GB
│
CY
SNAW 1000 D2
Displaying nutritional and energy values
1) Place the food on the weighing platform 1.
2) Look up the appropriate code for the food to be weighed from the food list
provided at the end of these instructions.
3) Enter the 3-digit code using the number buttons 4, e.g. 024. All nutritional
and energy values of the respective food appear on the nutritional/energy
value displays e.
KCAL: kilocalories
KJ: kilojoules
FAT: fat
CARB: carbohydrates
PROT: protein
CHOL: cholesterol
BE: bread units
NOTE
► As energy and nutritional values fluctuate naturally, these values only serve
as guide values.
► If you make a mistake when entering the code, simply re-enter the code.
Switching the scales off
Press the ON/OFF button 9 to switch off the scales. The scales switch off.
or
Wait about 60 seconds after the last action. The scales switch themselves off
automatically.
Saving a measurement
You can save all displayed values for a food. The scales will automatically add
the values to each saved measurement. For instance, you can enter every item of
food you eat over the course of a day and view the data at the end of the day.
The saved values are retained, even after you switch off the scales or change the
battery.
1) Weigh some food as described in the previous section and enter the appro-
priate food code so that the nutritional and energy values are displayed.
2) Press the M+ button 0 to save the measurement.
ΣM XX appears on the measured value memory display r. “XX” is displayed
as a two-digit number, e.g. ΣM 01 and shows the memory location.
To Next Page
Loading...
