■ 8
│
GB
│
IE
│
NI
Raclette
1) Oil the stone griddle 5 and the griddle 1 on the top and the pans 6 on the
inside.
2) Insert the plug into a mains power socket. The power indicator lamp 4 lights
up red to show that the appliance is connected to the mains.
3) Turn the temperature control 2 to MAX. The heat-up indicator lamp 3 lights
up green to show that the appliance is heating up. As soon as the heat-up
indicator lamp 3 goes off, the appliance has heated up.
NOTE
► The heat-up indicator lamp 3 may come on and go out several times
during this process. This is not an appliance malfunction! It merely indi-
cates that the appliance is maintaining the set temperature.
► Depending on the room temperature, heating up will start at different
positions on the temperature control 2. The appliance does not heat
up at normal room temperature in the striped area of the temperature
control scale 2. If you turn the temperature control 2 towards MAX,
you will hear a slight "click" and the appliance will start to heat up.
If you only want to use the raclette, allow the appliance to heat up for 10 min-
utes. If you want to use the stone griddle 5 at the same time to grill food, wait
around 30 minutes until the stone griddle 5 has heated up (see Chapter
"Grill").
The pans 6 do not need to be pushed into the appliance while it is heating up.
4) Fill the pans 6 with the desired ingredients. Ensure that the pans 6 are not
overfilled otherwise the food could get too close to the heating elements and
could even touch them!
5) Place the pans 6 into the device. The slight recess in the appliance helps to
keep the pans in place.
6) Turn the temperature control 2 towards MIN if you want to reduce the tem-
perature. Turn the temperature control 2 towards MAX if you want to increase
the temperature again.
7) Remove the pans 6 from the device as soon as the contents are cooked.
IB_288353_SRGS1400B2_LB6_GB.indb 8 03.05.17 09:10
To Next Page
Loading...
