SSBS 3.0 A1
■ 10
│
GB
│
CY
NOTE
► The next time you switch on the device, the remote
release will connect automatically to the last-connected
smartphone. If your smartphone does not automatically
connect to the remote release, you must establish the
connection manually. You can find a detailed description
of how to do this in the operating instructions for your
smartphone.
► If you want to connect another smartphone to the remote
release, press and hold the button! for about
2 seconds. The operating LED briefly flashes blue twice
and then continues to flash every second. The remote
release is now in pairing mode for about 1 minute and
can now be connected to another smartphone.
Attaching a smartphone to the selfie stick
♦ Pull the clamps of the smartphone holder open.
♦ Place the smartphone between the clamps of the smart-
phone holder by pushing the upper clamp upwards
against the spring force. Check that your smartphone is
securely in place.
♦ Loosen the locking screw and adjust the vertical tilt angle
of the smartphone. Fix the smartphone in the desired posi-
tion by re-tightening the locking screw.
♦ If necessary, attach the remote release to the lower part of
the telescopic shaft using the remote release holder..
To Next Page
Loading...
