9
GB
Dicing
1.
Figure G:
place the disk insert|
12
into
the container|
15
. Here, align the disk in-
sert|
12
so that its recesses engage in the
recesses at the container|
15
.
2. Place the blade assembly|11 on the
disk insert|12.
5.6 Multifunction drive cover
1. Figure H: place the drive cover|8 on
the container|15. Align the drive cov-
er|8 so that the marking |31 at the
handle|17 points to the attachment
marking |32.
2. Figure H: turn the drive cover|8 clock-
wise until it engages audibly. Now, the
marking |31 points to the lock
marking |33.
3. If necessary, insert the food pusher|7
into the refill opening|9.
4. Figure A: place the motor unit|1 on
the drive cover|8 and press it down.
The motor unit|1 must engage audibly.
5.7 Separating the motor
unit from the accessories
• Figure A:
in order to release the motor
unit|
1
press both buttons|
4
and remove
the motor unit|1 from the accessories.
6. Operation
DANGER! Risk of injury from
cutting!
~ Never reach into rotating blades. Do
not touch rotating parts with spoons or
similar utensils. Keep long hair or loose
clothing away from rotating parts as
well.
~ Only switch on the device when the
hand blender|24, the masher|23 or
the whisk|6 is immersed in the food.
~ The blade assemblies continue to rotate
after the device is switched off. Wait
until the blade assembly has come to a
standstill before you take the hand
blender|24 or masher|23 out of the
food or release the drive cover|8 /|28
from the container.
WARNING!
~ The device is designed for a maximum
operating time of 2 minutes without in-
terruption (see “Operating time” on
page 10).
~ In order to prevent damage to the de-
vice, interrupt the blending process im-
mediately if a blade assembly is either
turning with difficulty or not turning at
all. Pull out the mains plug|3 and check
whether there is something in the con-
tainer blocking movement or the food is
too tough. Also check whether the de-
vice is assembled correctly.
To Next Page
Loading...
