Silvercrest SSP 2600 A1 - Checking the charge level; Handling and use; Charging mobile devices with the power bank

SSP 2600 A1
■ 8 │ GB
│
IE
│
NI
LED display Charge level
One LED is flashing Less than 20%
One LED is on, the second
LED is flashing
20–49%
Two LEDs are on, the third
LED is flashing
50–74%
Three LEDs are on, the fourth
LED is flashing
75–99%
All LEDs are on 100%
Checking the charge level
You can also check the charge level of the power
bank when it is not charged or while it is being used
for charging.
♦ Press the on/of button  briefly. The charging
status LEDs  show the current charge level of the
power bank for about 30 seconds.
LED display Charge level
Four LEDs are on More than 75%
Three LEDs are on 50–74%
Two LEDs are on 25–49%
One LED is on 3–24%
One LED is flashing Less than 3%
Handling and use
Charging mobile devices with the
power bank
♦ Connect the micro-USB plug of the charging cable !
to the micro-USB port of the mobile device you want
to charge and the USB plug to the USB port -
on the power bank. The charging process starts
automatically.
♦ If charging does not start automatically, press the
On/Off button  briefly to start the charging
process.
NOTE
► Alternatively, you can also use the original charg-
ing cable (USB cable) provided by the respective
device manufacturer.