Silvercrest SSP 2600 A1 - Attaching a smartphone to the selfie stick

SSP 2600 A1
■ 10 │ GB
│
IE
│
NI
♦ If you want to stop the Bluetooth
®
connection
with your selfie stick, for instance, to separate the
devices, press the On/Off button for 2 seconds.
The Bluetooth
®
LED  flashes 3 times. The
charging status LEDs  light up and then go off
after about 30 seconds. The Bluetooth
®
function
is now turned off.
NOTE
► Press and hold the On/Off button  of the selfie
stick for 2 seconds to turn on the Bluetooth
®
function. The Bluetooth
®
LED  lights up for
approx. 7 seconds.
The charging status LEDs  light up and then
go off after about 30 seconds. The devices are
now connected via Bluetooth
®
. You may have
to confirm the Bluetooth
®
connection on your
smartphone.
Assembling the selfie stick
♦ Screw one of the threads on the mount  onto the
thread of the tripod head . You can assemble the
mount  vertically or horizontally. Fix the required
position using the fastening screw .
♦ Push the telescopic shaft  into the holes on the
selfie stick handle. Turn the telescopic shaft  clock-
wise a little until the telescopic shaft clicks into
the selfie stick. The telescopic shaft  and the
selfie stick are now connected to each other.
Attaching a smartphone to the selfie stick
♦ Open the mount  by pulling the spring clip open.
♦ Place your smartphone into the mount .
♦ Release the clip so that the clip snaps onto your
smartphone. Ensure that your smartphone is firmly
in place in the mount .
♦ Set the vertical tilt angle of the smartphone. Loosen
the fastening screw hinge joint 3 on the mount by
turning it anticlockwise. Lock the smartphone into
this position by turning the fastening screw hinge
joint 3clockwise.
♦ Set the horizontal alignment of the smartphone.
Undo the fastening screw on the mount by turn-
ing it to the right. Turn the fastening screw to the
left to lock the smartphone into this position.