SSP 2600 A1
GB
│
IE
│
NI │ 11 ■
Attaching a compact camera to the
selfie stick
♦ Unscrew the mount from the tripod head.
♦ Screw the compact camera onto the thread of the
tripod head .
♦ Set the horizontal alignment of the compact camera.
Undo the fastening screw on the mount by turning
it to the right. Turn the fastening screw to the left
to lock the compact camera into this position.
♦ Set the vertical tilt angle of the compact camera.
Loosen the fastening screw hinge joint 3 on the
mount by turning it anticlockwise. Lock the compact
camera into this position by turning the fastening
screw hinge joint 3 clockwise.
Taking selfies
Pull out the telescopic shaft to the desired length.
Turn the individual elements of the telescopic shaft
clockwise to lock them in place.
♦ If you want to unlock the telescope shaft turn
the individual elements in the opposite direction
(anticlockwise).
♦ Turn the camera function of the smartphone on. If
you are using a compact camera, make the required
photo settings on the compact camera.
♦ Press the photo button on the selfie stick. Your
smartphone or compact camera will take a photo.
The Bluetooth
®
LED flashes briefly and shows
an active Bluetooth
®
connection.
Turning off the appliance
♦ Press the On/Off button for 2 seconds to turn
off the selfie stick. The Bluetooth
®
LED flashes
three times.
NOTE
► The appliance turns off automatically after around
5 minutes, if you do not press any buttons during
this time.
To Next Page
Loading...
