Silvercrest STV 30 A1 - Before Use; Unpacking; Assembly

10 GB
Operation
m
CAUTION! Risk of injury!
Never use the product without
the safety grille or with a
damaged safety grille.
m
CAUTION! Risk of injury!
During use, keep hands, hair,
clothing and utensils away
from the safety grille to avoid
injuries and damage of the
product.
 Only use the product in dry
indoor rooms.
 Protect the product, its power
cord and power plug against
dust, direct sunlight, dripping
and splashing water.
 Before use
 Unpacking
 Remove the packaging. Check if all parts are
complete.
 Assembly
Fig. Step
A+B
Place the stand [8] on a flat, stable
ground.
Push the base unit [7] onto the stand [8].
C
Remove the grille lock nut [4] from the
drive shaft.
Place the rear grille [5] on the drive
shaft of the base unit [7].
Secure the rear grille [5] with the grille
lock nut[4].
D
Place the blade[3] on the drive shaft of
the base unit[7].
Secure the blade[3] with the blade lock
nut[2].
E
Open the locking clips[] on the front
grille [1]. Align the screw holes[] on
the bottom side of front grille [1] and
rear grille [5]. Make sure the clip[] is
well positioned.
F
Secure the front grille [1] by pressing
down the locking clips [] on the rear
grille[5].
G
Lock the front grille[1] and the rear
grille [5] with the screw and nut[9].