Selecting a saved station
• In order to select a saved station directly, first use the frequency selection
switch to select the frequency range where the station is saved.
• Press the
PAGE button and then use the UP or DOWN buttons to select a
memory page (from 00 - 39).
• Within 10 seconds press the
M.0/5–M.4/9 buttons to select a memory
space to store the station.
The station is played immediately after entering the memory space.
• If a memory space is selected in which no station has been saved,
- - - - appears on the display.
Carry out automatic station search
Your world receiver can search the frequencies within a range and store
the stations it finds. Do the following to activate the automatic search
(automatic memory scan/AMS):
• Press the
MEM button once. The MEM message flashes.
• Hold down the
MEMORY SCAN button for about 1 second.
The multi-band radio then scans through the frequencies starting from the
currently set frequency in the current frequency band and saves the stati-
ons found from the currently set memory page and the memory space. This
will overwrite all existing stations.
Displaying memory spaces
• Press the MEMORY SCAN button to call up the content of all station memo-
ries for the selected band.
All stored stations will be played in succession for about 15 seconds.
• Press the button
MEMORY SCAN to finish the rendering of the memory po-
sitions.
- 26 -
GB/CY
To Next Page
Loading...
