Silvercrest SWKK 2400 A1 - Page 14

SilverCrest SWKK 2400 A1
12 - English
Cord wrap
There is an integrated cord wrap on the
underside of the base (6). This enables
you to adjust the power cable (7) length
to suit your conditions.
When the kettle is not in use you can
reduce the cord length to a minimum here.
 Unwind the power cable (7) underneath the base (6).
 Place the base (6) on an even, non-slip and dry surface. Note that the power cable (7) must be
fed through one of the notches provided on the underside of the base (6) to ensure stable
positioning.
WARNING
If the power cable (7) is not fed through one of the notches provided on the
underside of the base (6), the base (6) and kettle (3) will not be stable. The
movement of the boiling water could make the kettle tip over causing severe
damage to property and personal injury!
 Open the lid (11) by pressing the lid release button (10).
"Minimum fill level" indicator
The minimum water fill level is 0.5 litres.
This low level is not visible on the outer
water level indicator (4).
A special mark indicating the exact
minimum fill level can be seen inside
the kettle (3) while filling with water.
This mark inside the kettle (3) is visible
when the lid (11) is open. An additional
mark indicates approx. 0.7 l of water.