200 GB/MT
Pull the energy cost meter plug out of
the mains socket.
Release the two screws on the back of
the device using a crosshead screw-
driver and take off the battery com-
partment cover
8
.
Remove the used batteries.
Insert three new batteries
(1.5 V
, recommended type: LR 44,
L1154F, A76, AG13 or RW82 ).
Note: Make sure you fit the batter-
ies the right way round (polarity).
The correct polarity is shown inside
the battery compartment.
Put the battery compartment cover
8
back on and tighten the two screws.
66149_silv_Energiekosten-Messgerät_Content_ES-IT-PT-GB.indd 200 25.05.11 12:21
To Next Page
Loading...