Silverline 633630 - Troubleshooting; Tool Operation Issues

EN
10
Problem Possible Cause Solution
Tooloperatingslowly
Pressure incorrect Setthecorrectairpressureaccordingtothespecication
Dirtwithinthemechanism Repeat the ‘Daily maintenance procedure’ several times to clear the dirt
Air blockage Operate tool in short bursts to clear blockage
Air leak
Checkallttingsandhoseforairleaksandcorrectissueby
re-tightening,usingPTFEtapeorreplacing
Tool seized
Dirt or rust in mechanism See‘Tooloperatingslowly’solutions
Dirt or rust in mechanism Taptoolgentlywithasoftmallet
Dirt or rust in mechanism Freemechanismbyrotatingdrivemanuallywhendisconnectedfromairline
Strongvibrationswhentoolis
switchedon
Accessoryttedincorrectly Removeaccessory,inspectfordamageandret
Accessory damaged (cracks, deformations or splinters) Replace cutting accessory
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Troubleshooting
633630_OwnerManual.indd 10633630_OwnerManual.indd 10 02/02/2024 14:2402/02/2024 14:24