1. meke sure the hoverboard is fully charged
2.Keep the hoverboard pedal parallel to the ground
3.Turn off the hoverboard; then press and hold the power button for about 10
seconds. (You will see the LEDs flash 5 -6 times and light up continuously after
6 flashes.)
4.Turn off the hoverboard once more to finalize the calibration
5.Turn on the hoverboard and it will be in good condition again, and you can
continue to use it without fear.
Get it serviced:
If the beeping continues despite your troubleshooting efforts, or if it's due to
a hardware or software issue, you might need to get your hoverboard
serviced by a professional or contact the manufacturer for further assistance.
In some cases, the hoverboard might need repairs or parts replacement.
12
To Next Page
Loading...