SIMDER
SD-4050MINI
Flux Cored MIG Welding
INSTALLATION
1.Install the flux core wire on the spindle adapter, As shown in the picture above
. If you need assist on wire setting, please visit our
website: www.ssimder.com for videos or contact us.
2.Connect the ground clamp to the “+” positive terminal on the
front panel, and tighten it clockwise, then clamp the ground clamp to the work-
piece.
3.Connect the MIG torch to the “-” negative terminal on the left
side, Connect the two-core control switch to the 2-pin connector in the middle.
4.Connect to power, turn on machine, choose Flux Welding Mode.
MMA Welding
1.Connect the electrode holder to the “-” negative terminal on the left side of
the front panel, and tighten it clockwise.
2.Connect the ground clamp to the “+” positive terminal on the
front panel, and tighten it clockwise, then clamp the ground clamp
to the work-piece.
3.Connect to power, turn on machine, choose ARC Welding Mode.
TIG Welding
1.Connect the TIG torch to the “-” negative terminal on the left side of
the front panel, and tighten it clockwise.
2.Connect the ground clamp to the “+” positive terminal on the
front panel, and tighten it clockwise, then clamp the ground clamp
to the work-piece.
3.Connect to power, turn on machine, choose TIG Welding Mode.
To Next Page
Loading...