8
Cross-Linked Cable (Part Number : 9503-000-00018)
The cross-linked cable simply swaps the Tx/Rx Data lines (enabling the two Transceivers to communicate), and cross-connects the Receive and
Mic Audio lines so that the audio signals can pass between the Transceivers. You can easily make one up by splitting a short CAT5 patch cable
and re-jigging the connections.
Editor’s note:- Pin 5 on both RJ45’s is left un-connected. I believe this is not the case on the crossover lead supplied to LDSAMRA.
This diagram shows the pin-out and part number of the Crossover lead. It can be made up to virtually any length using standard CAT5 components.
From Simoco, the cost is about £12. All SRM9000-based versions of the re-broadcast device require this cable to be fitted.
Note that the two radios are placed into rebroadcast mode as soon as the crossover cable is connected.
Information taken from TMC publication - A9k-501 “Simple Repeater” available from the TMC Radio website at www.tmcradio.com
To Next Page
Loading...
