Fig. 118
Fig. 119
Fig. 120
6.6.2 reMOval OF THe MaGneTic
SenSOr
This sensor serves to detect the presence of
water inside the tank. In case of breakdown or
malfunctioning, it can be replaced.
1 Take out the water tank from its housing and
remove the rear panel.
2 Unscrew the sensor "A" with a wrench, hold-
ing the locking nut with pliers.
6.6.3 reMOval OF THe TanK Mi-
crOSwiTcH
To remove the tank-detecting microswitch, pro-
ceed as follows:
1 Take out the water tank and remove the rear
panel.
2 Disconnect the electrical connections.
3
Loosen the locking screws of the micro-
switch using a 2,5 mm Allen key.
To Next Page
Loading...
