mount with tape:
1
2
3 4
clean the surface
prepare
mount and wait
finish
• Use any household bathroom cleaner
and thoroughly scrub the surface.
• Wipe with alcohol pad provided.
• Allow surface to dry fully or adhesive
will not set properly.
NOTE: For porous or uneven surfaces,
screw mount method is recommended.
• Peel off tape backing.
• Press the wall plate firmly for at least
30 seconds to secure the adhesive.
• Snap the accessory clips into the
dispenser.
• Push dispenser down until it locks
into place.
• To clean the pumps while they’re still on
the wall, fill them with water and then
pump until all the water is gone.
• You can also remove the pumps and
clean them with warm, soapy water.
• Do not use abrasive or chemical
cleaners, and do not put the pumps in
the dishwasher.
• Soaps with exfoliants or moisture beads
may clog the pumps.
use and care
before mounting dispensers:
• wait minimum 2 hours
• for best results wait 24 hours
To Next Page
Loading...