simplehuman ST1008 - Quick Start Guide; Insert Batteries; Fill Reservoir; Prime the Pump

prime the pump
1
quick start
• use a screwdriver to
remove battery cover
• insert 4 AA batteries
as shown
• lift off the lid on top of
the chamber to fill
Note: Do not use soap
with exfoliants, and be
careful not to overfill.
insert batteries
fill the reservoir
1
2
3
• place your hand under
the sensor
• hold down button
until soap comes out
+
If the soap doesn’t flow, lightly
flick the valve opening to
release any trapped air.
Note: Only use alkaline batteries.
tip: priming problem?