EasyManua.ls Logo

Simplex 2120 - Introduction to Simplex 2120 System; Receiving and Inspecting Simplex 2120 Equipment; Simplex 2120 Basic System Components

Simplex 2120
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Symbol Definitions
.
u
\
0
0
FLOWCHARTS
This symbol is used to request a certain act, test or
performance. Perform the action before continuing.
This symbol will contain a simple question - usually
based on the action that preceded it. Two points will
be labeled
- one point “yes”, the other “no”. Exit at
the point which provides the correct answer to the
question.
This symbol indicates that the steps are continued on
another flowchart. The flowchart figure number will be
written inside the symbol. Flowchart figure numbers
appear at the bottom of each flowchart. A similar
symbol with a reference to the previous flowchart
figure number will appear on the figure indicated.
The reference symbol is used when additional
information is available, and it is always connected to
an action symbol. Refer to the referenced material
prior to performing the action.
This symbol indicates that the steps are continued on
another part of the same page. The number within the
circle will match the number in a circle at the point
where the flow continues.
This symbol indicates that a very serious malfunction
exists and additional assistance is required. The
information within the symbol will recommend a
source of aid.
firealarmresources.com

Other manuals for Simplex 2120