8
Connect the 14-pin end of part 734-038, which is one of the ribbon cables shipped with the board,
to the connector on the UL I/O board shown in Figure 6. Be sure to count the number of holes on
each end of the cable, one has 16 pins and the other 14. The 14-pin end is what you must connect.
Attach the cable so that the colored stripe is on the bottom.
Figure 6. New UL I/O Cable Placement
Connecting the New UL I/O Cable
Attach 734-038
here
Front
Rear
Top
Bottom
To Next Page
Loading...
