All Supreme shower doors and panels are fully assembled and
are reversible for left or right hand tting, simply turn the door or
panel up side down.
The Supreme doors come with the two wall channels pushed
onto each side of the door frame. The side panels and inline
panels do NOT come with wall channels, you must use one of the
channels from the door.
The installation instructions are based on typical use and
conditions.
The pivot doors are designed to open outwards only.
Please follow the installation instructions relevant to your
enclosure.
These hints have been prepared for your guidance, you must
exercise due care at all times.
It is recommended that 2 people carry out the installation of this
enclosure.
Handle glass with care. Although the glass supplied is toughened
safety glass (to EN12150), impacts can damage both the glass
and the frame.
Warning! Please check for any hidden pipes or cables before
drilling holes in the wall.
To stop the drill bit slipping, masking tape can be applied to the
tiles when preparing the holes.
When using power tools always follow the manufacturers user
instructions.
Do not sit the enclosure on a bed of silicone, as this will also stop
any water from draining back into the tray.
DO NOT SEAL THE ENCLOSURE TO THE TRAY ON THE
INSIDE
If the enclosure is sealed to the tray on the inside, any water that
may get into the framework will not be able to drain back into the
tray, this may cause the enclosure to leak.
Leave the silicone sealant to dry for 24 hours before using the
enclosure.
Do not use solvents or abrasive materials or chemicals to clean
the enclosure.
Only clean using soapy water and a soft cloth, rinse thoroughly
afterwards.
Please read these instructions carefully before starting
installation and keep in a safe place for future reference.
Check the contents of the pack carefully before installation.
Simpsons will not be held responsible for any de-t / re-t costs
where faulty product has been tted.
If any fault is found with materials or workmanship, it must be
reported immediately to the manufacturer. Remedial action will
be taken, based on information received, on condition that: 1. Full
details are supplied to the manufacturer; 2. The enclosure has not
been modied or tampered with; 3. The manufacturer is informed
of any damage/shortages prior to installation.
We do not accept responsibility for any problems that may occur
through incorrect installation.
The success of the installation and operation of any shower
enclosure is, of course, dependant on the squareness, alignment
and construction of the walls to which xing is to be carried out.
VERY IMPORTANT
You must complete all tiling and grouting, and the shower tray
MUST be level and fully sealed to the tiles before installation. If
you do not t the enclosure onto a tiled surface, or seal the tiles
to the tray before installation, water may soak into the wall behind
the wall channels.
IMPORTANT - Please read before installation
INSTALLATION - Advice and safety
CARE AND CLEANING
1
To Next Page
Loading...