Simrad Naviop Loop M - Activating the Loop M control bar feature

| 25
Conguration | Loop M User Manual
12 Turn the MFD on and wait until the installation is complete.
13 When the MFD has booted up, remove the storage device.
14 Activating the Loop M control bar feature.
The Loop M control bar feature should be automatically enabled when the MFD is configured
and the Loop system is correctly installed. If it does not show up, you can manually activate
the feature from the advanced system settings.
A
The application name (A) in the menu is the same as the name assigned in the Set App.
¼ Note: Perform steps 6 to 9 for each MFD that you would like to operate the Loop system.
¼ Note: Perform steps 10 to 14 for each MFD to enable the control bar feature.