28 |
Operation | Loop M User Manual
E Diagnostic page two (Loop M+ only)
Status of Egon+ board two (CAN ID:2)
Control page
The number of available buttons (A) depends on the configuration and connected
equipment.
Buttons
The button indicates the status of the connected equipment.
O (black)
The relay is open.
On (blue)
The relay is closed.
Override (yellow)
The relay control is bypassed by an external switch or the
equipment is powered from another source, not via the relay.
Error (red)
The fuse and/or relay is broken. For more information refer to
“Diagnostic page” on page 29.
The buttons can be configured either as toggle buttons or as momentary buttons. Refer to
“Configuration” on page 21.
Toggle buttons change status when pressed. If it is off it will be turned on when pressed and
vice versa.
Momentary buttons are activated as long as they are pressed.
To Next Page
Loading...