Merge error
You have tried to MERGE data or code. You can only MERGE programs.
This report will also appear if you have tried to MERGE a program saved by
the SAVE . . . LINE.. statement.
Microdrive full
You have tried to write data to a cartridge containing no free space. You
should therefore run your program or command again, with a cartridge that
does contain free space. This can be done by erasing old files from the present
cartridge. A file opened for writing on the full cartridge cannot be cloned.
It should be erased. This will, however, take about thirty seconds because the
computer checks the cartridge several times to make sure that the file has
no end.
Microdrive not present
You have either tried to use a Microdrive which is not attached to your
computer. or a Microdrive which does not contain a cartridge. or a Microdrive
containing an unformatted cartridge.
Missing baud rate
The baud rate has not been specified.
Missing drive number
The Microdrive number has not been specified.
Missing name
The file name has not been specified.
Missing station number
The network station number has not been specified.
Program finished
You have tried to execute a line beyond any existing line. This report will
appear if a GOT0 instruction is followed by a number beyond any existing
line. It will also appear if RUN is typed without a program.
Reading a ‘write’ file
You have tried to input data from a file which does not yet exist, or which
has already been opened for input.
52
To Next Page
Loading...